• money_loo@lemmy.world
    link
    fedilink
    arrow-up
    3
    ·
    1 year ago

    Holy shit this explains so much!

    Our dishwasher in a 2010s era home finally died, and when we pulled it out to install a new one there were these off center holes behind it!

    Like, wtf? Why did you need three holes for one cord?

    I guess during construction different people thought it wise to drill different holes for different things?

    • railsdev@programming.dev
      link
      fedilink
      arrow-up
      7
      arrow-down
      1
      ·
      1 year ago

      When I was a kid I always wondered why things like coaxial, telephone lines, Ethernet are not put into some type of pipe so they can be switched out easily in the future.

      Why do we have to tear up walls to replace this stuff?

      • droans@lemmy.world
        link
        fedilink
        arrow-up
        4
        ·
        1 year ago

        Laziness more or less.

        It’s easier and cheaper to just run one wire. Most people don’t want more than a couple different port locations so why bother?

        And you’re not installing the other two items so it’s not your responsibility. You’re also not going to get paid more for doing the extra work. Even if the homeowner was the one paying you, most aren’t willing to pay a bit extra just so it’s easier on the next guy.

      • Dozzi92@lemmy.world
        link
        fedilink
        arrow-up
        4
        ·
        1 year ago

        This is interesting. I did my garage from the studs out. Using conduit to run electrical never even occurred to me. I think it would be a real bitch to drill holes through each stud level enough to push a rigid conduit through. Maybe there are some flexible conduits, but now you’re taking a 1/2" hole and making it a full inch, in a 2*4, which is nominally 1 and 3/4". But now I’m thinking they did it with Bx, and maybe I’m not fully versed on why. I know the shielding acted as a ground as well.

        I’m rambling. I think there’s some rationale that’s not just capitalism=bad. Code is okay with running straight Romex through studs, so long as you staple and whatnot. Maybe it’d be above code to use conduit, but I think it’s just a lot of extra work for not very much payoff. So yeah, capitalism=bad, I guess.

        • railsdev@programming.dev
          link
          fedilink
          arrow-up
          3
          arrow-down
          1
          ·
          1 year ago

          Yeah now that I’m older I realize it would probably be a pain to do but decided to bring it up again for fun. Lol

          With Ethernet specifically (because I’m a freaking computer nerd) what I hate is these houses that have like 100 Mbps (CAT5) from just a few years ago, and you’re stuck with it unless you want to tear up the whole place.

          • Dozzi92@lemmy.world
            link
            fedilink
            arrow-up
            3
            ·
            1 year ago

            So during my garage retrofit, I did run, in addition to 100amps for a panel, a separate conduit with two Cat6s. In the event of upgrades in tech, I can easily pull that through and replace with Cat7 or whatever. I won’t, but I could. It’s about 90ft from the house to the garage.