Hi all Lately, my printer has been throwing tantrums. It happens that when it starts up, it refuses to connect to Klipper on my RasberryPi. I don’t know if it’s because I’m using a smart plug to turn off my printer or if it’s an update that has a broken roof. The only solution I found was to flash the original firmware and flash klipper again.

No one would have a clue please?

  • dmention7@lemm.eeEnglish
    0·
    10 months ago

    Can you provide any more details on what is not working and what might have changed since things stopped working? There is not a lot of info to go on.

    I’ve been running Klipper on a Raspberry pi with an Ender 3 S1 Pro for about 8 months with virtually zero hiccups, but I’d hardly claim to be an expert.

  • neal33@lemm.eeEnglish
    0·
    10 months ago

    I had a similar issue when I initially installed Klipper on my Ender 3 S1 (not the plus). It would not connect unless I fully restarted Octoprint whenever I turned on the printer. The change I needed to make was go into settings in Octoprint (though I assume its similar on other front ends), and add the following settings:
    Serial Port: /tmp/printer
    Baud Rate: 11520

    If that is not the case for you, try to add some more details. Do you have the config file correct?